Gary L. Burnore
Guest
|
 Posted:
Mon Dec 20, 2004 1:47 am Post subject:
Pig Bushing Replacement |
|
|
Bad news Good News Bad news.
Bad news. Driving home last night, my Cressida stopped moving in a
forward direction and I heard the tell-tale sound of a busted drive
shaft.
Good news. Drive shaft not busted.
Bad news. Side shaft busted? 60 Bucks for a tow. Feh.
Out comes the Repair Manual. Man, this could be bad. Lift the car.
Look underneath. Driver's side shaft is completely out of the socket
but...
Good news: The socket is just fine.
Bad news: One of the two rear bushings is gone.
Good news: I had already bought new rear differential mounting
cussions for both sides of the rear and the two that go in the front.
I just didn't buy a 12MM allen wrench to take it apart.
Bad news: It'll be easy to remove the pig. Easy to replace it too.
But these bushings appear pressed in. I don't have a T&M book, but
from the looks of it, I'm expected to remove the differential mounting
cushions with a tool (SST# 09570-22010) Toyota says they never made.
The dealer says they take the entire rear assembly off at the mounts
to the body and stick it in a press. WTF?????
|
|
Guest
|
| Posted:
Mon Dec 20, 2004 2:58 am Post subject:
Re: Pig Bushing Replacement |
|
|
Did you try a hammer an chisel? ;)
mike hunt
"Gary L. Burnore" wrote:
| Quote: |
Bad news Good News Bad news.
Bad news. Driving home last night, my Cressida stopped moving in a
forward direction and I heard the tell-tale sound of a busted drive
shaft.
Good news. Drive shaft not busted.
Bad news. Side shaft busted? 60 Bucks for a tow. Feh.
Out comes the Repair Manual. Man, this could be bad. Lift the car.
Look underneath. Driver's side shaft is completely out of the socket
but...
Good news: The socket is just fine.
Bad news: One of the two rear bushings is gone.
Good news: I had already bought new rear differential mounting
cussions for both sides of the rear and the two that go in the front.
I just didn't buy a 12MM allen wrench to take it apart.
Bad news: It'll be easy to remove the pig. Easy to replace it too.
But these bushings appear pressed in. I don't have a T&M book, but
from the looks of it, I'm expected to remove the differential mounting
cushions with a tool (SST# 09570-22010) Toyota says they never made.
The dealer says they take the entire rear assembly off at the mounts
to the body and stick it in a press. WTF?????
|
|
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in
